Does anyone have an interest in assorted JD Trailfire Parts?
I have a pile of left over 1979-1980 340/440 John Deere Trailfire parts.
I have listed stuff on Ebay a few times and no luck. I hate to throw it away, but I'm just about to that point. I'm out of the JD sleds and just want these parts gone, would prefer parts go where they may someday be used.
Do they share anything with the liquifire? I know a guy looking for carb boots for a liquifire.
My brother is working on a 488 fan version. he was looking for a pipe. maybe a chain case also. his is cracked and need to change to something.
I'll go inventory it all and post a list. Be easier since there is some interest.
Ok Here is the list.
2 - Complete track cogs and shaft --- listed on Ebay
1 - Gear Set ----- Listed on Ebay
2 - Complete chaincase and cover assembly - No gears or chain
1 - Complete 440 engine shroud - metal covers
1 - recoil pull start assembly
1 - flywheel
1 - fan blade cover
1- exhaust manifold y-pipe -- been welded repaired
1 - steering post
1 - engine plate
2 - rear idler wheels -- no bearings
1 - fan shroud - fan - coil assembly fan rubs might just need adjustment or grease
1 - top idler cross shaft and idler wheels
1 - fuel pump
7 - NEW chain tensioners JD part# AM54384
1 - Track suspension front arm
2 - Jackshafts with brake disc
1 - rear idler track adjuster bar --- grooves worn at an angle
1 - brake assembly with good pads
1 - Secondary clutch
1 - tail light housing, socket, and wiring -- rusty
2 - hood vent grills great shape.
1 - PTO side 440 head -- good condition
1 - Mag side 440 head -- good condition
2 - track drive cogs wheel
1 - bag of track cleat bolts ?#
2 - angle speedometer drives
1 - good stator assembly
1 - JD Tach
1 - JD speedo
1 - hood strap/latch
1 carb to airbox boot small tear
Please Dont Throw the parts..
stuff is getting harder to find.
Go to vintage sleds classifieds/sled bull session, I'm sure there will be people that will take/buy them.
I haven't and have listed them couple places with no interest or such a low ball offer that I just wouldn't do it...
I have everything still in the list. I just can't pitch good useable parts!!! want the shelf space, but won't scrap it.
I know this is a long shot since it is over a year later but it doesn't hurt to try. By any chance do u still have the track drive cods? and if so how much do u want for them? Also looking for a track as well.
Actually that is one of the only parts I have left. I have two drive cog assemblies...
Pay shipping and they are yours.. Tracks I sold along with other parts...
|All times are GMT -5. The time now is 11:02 PM.|
Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright 2007 Slednutz.com