SledNutZ

SledNutZ (http://www.slednutz.com/index.php)
-   Snowmobile How-To's (http://www.slednutz.com/forumdisplay.php?f=64)
-   -   Base gasket installation (http://www.slednutz.com/showthread.php?t=5889)

Rubi 12-05-2011 11:17 PM

Base gasket installation
 
Do you put any kind of liquid gasket material on the cylinder base gaskets? I didn't on my other 600, but the one I'm doing right now has tons of unidentifiable spunk on it from the previous owner. Which way is right?

rock2324 12-05-2011 11:51 PM

dry.

stagesrt4 12-06-2011 12:10 AM

Dry prefer

If needed use permatex

Ibreakstuff 12-06-2011 09:23 AM

Fuck that dry shit, I put permatex Ultra Grey on mine before I learned it was bad to do. Now since I've been doing it "correctly" I've lost 2 base gaskets - both on waverunners. Ultra Gray or Black - better yet - use Threebond and you're really set.

Gotmud 12-06-2011 09:27 AM

Dry

thebreeze 12-06-2011 09:50 AM

Dry.

Powersledder 12-07-2011 07:24 PM

Preferred method is dry, but I had to use Hondabond or yamabond or whatever the hell its called on my Cometic Gaskets.

Slamdry 12-08-2011 12:51 PM

I just did mine dry. Seemed to seal fine. Just get her good and clean first.
the rubberpronged gasket remover for a hand held 2" angle grinder did the trick for me.

The Baller 12-08-2011 12:54 PM

What brand of gaskets did you end up getting?

Slamdry 12-08-2011 01:05 PM

I ended up with a winderosa kit. Best price and had everything I needed

The Baller 12-08-2011 01:08 PM

I see, I am just wondering about how much unnecessary work I should do to my sled once I start doing unnecessary work to it.

Slamdry 12-08-2011 01:23 PM

If your doing top end you kind of need to do base.
I mean I had under 200 in my top end and that was factory rings and sending the head out to be milled
but I has to do mine due to needing to find where the coolant was going.


All times are GMT -5. The time now is 02:08 AM.

Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright 2007 Slednutz.com