how to change speedo key
if your speedo quits working, then there is a good chance this little key broke off,
1:remove the secondary clutch, this is just to get you some elbow room
2: remove 3 nuts that are holding the gear drive on to the bearing.
3: remove cover, there will be part of the key in this cover, pull that out
4: the other part of the key will be in the axle, wipe all the grease away, now if you can grab the key with an oring pick or needle nose then put in new key and reverse the other steps. BUT, if you cant pull out the key do this little trick.
get a sharp small chisel or a sharp screw driver, I mean very sharp. with the grease cleaned away you will see there is a shoulder, tap the chisel at the back of the shoulder against the axle. then after a couple taps, rotate the track 180 degrees, tap again, it should only take a couple times and the insert will pop out. now simply remove the broken key, tap the insert back into the axle and put the new key in the bearing cap and reassemble.
If the boner police are here I need a lawyer.
in a time of deciet telling the truth is a revolutionary act. george orwell.
aint no body ripin like me. M to the a-d-c-o-w. rock it hard for my fly ladies. I rock it yes in deed
. homies still roll with me. money dont change me
nothing goes like 3 holes.
high performance engineering