You will need the CRC steering set up,steering shaft and post from a 98xcr440 to do it. It was made to steer around the water pump housing. I have the set up off the sled in my avatar if you want measurements or to talk about purchasing. We would have to measure to see if it would even fit in an evolved chassis. I'm not schooled on the 03 440 but I am running a 2000xcsp 440 valve motor that is now in a 2003 pro-x chassis....I had to do many changes to make it trailable...but it was worth it....A properly set up valve 440 will give and non piped 600 xlt a run for its money until 70mph any day...
What worries me is you said race motor......That normally means high octane head, unless its been changed. Also the TMX mikunis that are prolly on that motor are pieces of shit
A garage full of Poo.....
I've never had a ten, But I've had five twos
Last edited by dodger : 10-27-2009 at 05:45 AM.